Troubleshooting - PRODUX PRO 29848 Manual

Troubleshooting

Problem
The heater will not operate,
when it is plugged in the
switch, and the thermostat
is switched on.
The heating element
glowing
The appliance didn't heat
up, or only ventilator
worked
Abnormal noise
Technical data chart
Model identifier(s): 29848
Item Symbol
Heat output
Nominal heat output Pnom
Minimum heat output Pmin
(indicative)
Maximum continuous Pmax
heat output
Auxiliary electricity consumption
At nominal heat output elmax
At minimum heat elmin
output
In standby mode elSB
Produx_29848_Multi_220623.indb 22
Possible cause
The plug is loose, bad
connection
No power in socket outlet
The input voltage is too high
or too low
The air inlet grill is blocked
The switch was not put at
heating setting
The thermostat operated
The self-resetting cut-out
operated
The appliance does not stand
upright
Value Unit Item
Type of heat input, for electric storage local space heaters only (select
one)
3 kW Manual heat charge control with integrated thermostat
1.5 kW Manual heat charge control with room and/or outdoor
temperature feedback
3 kW Electronic heat charge control with room and/or outdoor
temperature feedback
Fan assisted heat output
N/A kW Type of heat output/room temperature control (select one)
N/A kW Single stage heat output and no room temperature control
N/A W Two or more manual stages, no room temperature control
With mechanic thermostat room temperature control
With electronic room temperature control
Electronic room temperature control plus day timer
Electronic room temperature control plus week timer
Other control options (multiple selections possible)
Room temperature control, with presence detection
Room temperature control, with open window detection
With distance control option
With adaptive start control
With working time limitation
Treatment
Pull out the plug, check the connection of the plug and socket.
Then connect again.
Insert the plug in a proper socket
Use power supply according to the rating on the label
Keep the heater far way from articles like curtain, plastic bag,
paper and other things which can cover the inlet or can be easily
cover on the air inlet
Turn the switch to heat setting
Turn the thermostat and listen if there is open/close voice. If
there is no click and the thermostat is not damaged, the heater
will automatic switch on when the appliance cooled down
Turn the heater off and inspect the blockage of inlet or outlet.
Disconnect the plug and wait at least 10 minutes for the
protection system to reset before attempting to restart the
heater.
Put the heater on a level surface
22
Unit
[no]
[no]
[no]
[no]
[no]
[no]
[yes]
[no]
[no]
[no]
[no]
[no]
[no]
[no]
[no]
23/6/2022 1:56 PM