Girard Products GMW09AB User Manual page 9

Bottom Duct Installation (sold
together with FMSN09A-BL-TK or
FMSN09-SS-TK trimkit))
1. Mark out the cabinet center line as shown
in the figure below.
2. Locate the bottom duct into the cabinet
opening. Ensure the duct bottom is center
aligned to the cabinet center line. Fix the
bottom duct with four M4 x
tapping screws.
Bottom duct and cabinet
are aligned as shown.
Cabinet center line
/ " self-
3
8
Trim Kit Installation
(FMSN09A-BL-TK/FMSN09A-SS-TK,
not included)
1. Remove the trim kit from the packaging.
Check to make sure it is not damaged.
2. Fit the trim kit over the oven front panel
and fix with four M4 x
screws on side.
Upper Duct Installation (sold together
with FMSN09A-BL-TK or FMSN09-
SS-TK trimkit))
Install the upper duct on the top of the oven
and fix it with four M4 x
screws.
- 8 -
/ " self-tapping
5
8
/ " self-tapping
5
8
CCD-0006006 Rev: 09-22-22