Step 2. Assembly; Spray Gun Assembly; Step 3. Select Suitable Location; Outdoor Use Only - NorthStar M157119G Owner's Manual

Step 2. Assembly

Note: Remove contents from packaging to begin
assembly.

Spray Gun Assembly

1.) Attach the Lance to Spray Gun.
a.) Tighten spin-on coupler hand tight.
Note: The o-rings create a seal so there is no need to
tighten with a wrench.

Step 3. Select Suitable Location

Mounting Instructions:
1. The pressure washer should be positioned on a
firm, level (less than 3 degree slope), heat-
resistant surface with good drainage and a
nearby water supply.
2. The pressure washer should be placed within
garden hose distance of a continuous water
supply. Ensure that the pressure washer sits
level and will not slide or shift during operation.
If applicable, block the pressure washer's
wheels to prevent movement.
3. Situate so there is adequate pulling room for
starting the engine using the recoil starter.
Attempting to pull at an odd angle could rip off
grip cord and/or cause muscular injuries to the
operator.
4. Mounting dimensions and pattern is as shown
below in fig06747.
supplied flange bolts (Part # 82625) and flange
nuts (Part #82631) and secure to 23 ft-lbs.
torque.
Initial Set-Up
WARNING: Lifting hazard
The pressure washer is heavy. It can crush and cause
serious injury or tips over. Follow the instructions below
for safely moving the pressure washer.

Outdoor Use Only

Select a suitable outdoor location:
1. Never run the pressure washer in an enclosed
or partially enclosed location such as a building,
garage, barn, shed, or house. These spaces
can trap poisonous gases. Running a fan or
opening windows will not provide adequate
ventilation to prevent dangerous CO build-up.
2. Only use the pressure washer outdoors at least
20 feet from the home, away from windows,
vents, and air intakes, to allow proper
ventilation. If you start to feel sick, dizzy, or
weak while using the pressure washer, shut off
the engine and get to fresh air RIGHT AWAY.
3. Position the pressure washer so that the
exhaust fumes will not be directed towards
people or building air intakes.
4. Do not locate and use the pressure washer in
the presence of flammable vapors, dust, gases,
or other potentially combustible materials.
5. Ensure that working, battery-operated or battery
back-up carbon monoxide alarms are used in
any dwelling/structure that is in close proximity
to the running pressure washer.
6. Note that this pressure washer is NOT designed
or approved for use in vehicles or marine
applications. Never run the pressure washer
inside RVs or other vehicles, on boats, or on
pick-up truck beds.
7. WARNING: Location hazards
Used
Choose a suitable site for operating your pressure
washer to prevent possible death from carbon monoxide
poisoning or injury from fire/explosion, hot surfaces or
equipment tip-over.
Airflow:
1. Situate so there is adequate clearance around
pressure washer to allow for airflow – at least 7
feet from any non-combustible wall or
obstruction.
2. Do not operate with a tarp, blanket, or cover
surrounding the machine.
12