Table of Contents
Advertisement
Flange Configuration
WARNING! Be certain seals and screen are properly positioned and clean any time the flanges are
reconfigured. Improperly installed or dirty seals or screens could cause leaks and the potential for fire or
explosion
CAUTION! Always be certain the power switch is accessible after reconfiguring the inlet and outlet ports.
The inlet and outlet flanges of your pump can be configured horizontally.
DC Power Connection
DANGER! Be certain the power switch is "OFF" prior to connecting the battery clamps / power cables to the
power source or installing the cable into the pump to prevent unexpected starting of the motor. Unexpected
motor start can cause unintended discharge of fuel, creating an explosion and fire hazard.
Inspect power cable before each use! Damage to the
outer jacket of the cable that exposes wiring requires
replacement of the power cable.
Install power cable by aligning flat on plug with front of
pump. HAND TIGHTEN ONLY! The power cable
terminates in black, and red clamps. All two clamps must
be used.
1. Connect the black (negative) clamp to the
negative post of the DC power source.
2. Connect the red (positive) clamp to the positive post
last.
Clamps should be disconnected in reverse order.
WWW.TMGINDUSTRIAL.COM
Inlet
P087/20
Outlet
Black
Red
1
Toll Free:1-877-761-2819
2
Advertisement
Table of Contents
