Page 2
1..19 IMPORTANT! When Installing Please Read Before Starting Place of Installation This air conditioner meets strict safety and operating • If possible, install the unit in a shady location. If the site standards. As the installer or service person, it is an is exposed to the sun, you should provide a sun screen important part of your job to install or service the system as shown in Fig.
2..19 Table of Contents 1. PRODUCT CODE ILLUMINATION AND SERIES INTRODUCTION....3 2. PRODUCT TECHNICAL PARAMETER ............4 3.PRODUCT SPECIFICA TION................ 5 4. KNOCK-DOWN DRAWING AND LIST OF COMPONENT ......6 5. WIRING DIAGRAME..................8 6.MAIN COMPONENTS AND ACCESSORIES' NAME........9 7.MAINTENANCE AND TROUBLE SHOOTING..........
4..19 The manufacture reserves the right to change any product specifications without notice. Item UNIT HW-18CK03 Cooling capacity 5000W Heating capacity Power supply 1PH,220-230V ,50Hz Power input 2000 Cooling Running current Power input Heating Running current Indoor side dB(A) Sound Level...
..9..19 ..9..19 ..9..19 ..9..19 6. MAIN COMPONENTS AND ACCESSORIES' NAME Machine body Air inlet (outdoor side) Front panel Air outlet (indoor side) Operation panel Air inlet (indoor side) Cabinet Operation panel Ventilation lever Auto swing switch Thermostat switch Mode selection switch : http://splitoff.ru/tehn-doc.html...
..11..21 10..19 AND TROUBLE SHOOTING 7.MAINTENANCE 1.Maintenance Air filter cleaning: Please clean the air filter every two weeks When dirt accumulates in the air filter, air circulation will be blocked, and causes poor cooling. It is advisable to clean the air filter every two weeks for efficient operation. Removal of air filter PUSH (1) Loosen the air inlet by pushing "...
Page 12
..13..21 ..11..19 Tips For Energy Saving Avoid opening door and window Don't be exposed to cold air for as much as possible a long time. Keep heat sources away from Use curtain or blind so t h e a i r c o n d i t i o n e r Direct sunlight may reduce cooling effect, always use window curtain.
Page 13
..12..19 ..14..21 WARNING To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Page 14
Troubleshooting Information ..15..21 ..13..19 WARNING To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Page 15
..14..19 ..16..21 Troubleshooting Information WARNING To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be connected.
Page 16
..17..21 ..15..19 Troubleshooting Information WARNING To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be connected.
9. INSTALLATION AND REPAIRING Installation of air conditioner (only for reference) 1. Make a wooden frame. (Fig.1) Metal support Model HW-18CK03 2. Attach a metal support (not provided by Thickness of wall manufacturer) in a firm location with expanding Fig.1 screws or bolts.
Page 19
..18..19 Installation Guide ..20..21 Selection of the installation position 1. Select position where the structure is firm. 2. Select position where the air inlet and outlet are not blocked by obstacles. 3. Select position where the cooled air can be blown to every corner of the room. 4.
Page 20
Before asking for service, check the following first. Phenomenon Cause or check points ..19..19 ¡ When unit is stopped,it won't restart immediately until The system does not ¡ 3 minutes have elapsed to protect the system. restart immediately. ¡ When the electric plug is pulled out and reinserted, the ¡...