Nedis ZBSM10WT - Zigbee Motion Sensor Manual

Intended use

The Nedis ZBSM10WT is a wireless, battery powered motion sensor.

You can connect the product wirelessly to the Nedis SmartLife app via the Zigbee gateway.

When connected, the current and past motion detection is displayed in the app and can be programmed to trigger any automation.

The product is intended for indoor use only.

The product is not intended for professional use.

Any modification of the product may have consequences for safety, warranty and proper functioning.

Specifications

Main parts (image A)

1. Function button
2. Status indicator LED
3. Battery insulation tab

Connecting to the Zigbee gateway

Make sure the Zigbee gateway is connected to the Nedis SmartLife app.

For information on how to connect the gateway to the app, consult the manual of the gateway.

1. Open the Nedis SmartLife app on your phone.
2. Select the Zigbee gateway to enter the gateway interface.
3. Tap Add subdevice.
4. Remove the battery insulation tab A.
   The status indicator LED A starts blinking to indicate pairing mode is active.
   If not, press and hold the function button A for 5 seconds to manually enter the pairing mode.
5. Tap to confirm A is blinking.
   The sensor appears in the app when the product is successfully connected to the gateway.

Installing the sensor

1. Remove the film of the tape.
2. Stick the product onto a clean and flat surface.

The product is now ready for use.

1. Open the Nedis SmartLife app on your phone.
2. Select the Zigbee gateway to enter the gateway interface.
3. Select the sensor you want to view.

The app shows the measured values of the sensor.

• Tap Set alarm to switch the low battery alarm on or off for the selected sensor.

Creating an automated action

1. Open the Nedis SmartLife app on your phone.
2. Tap Smart scenes at the bottom of the home screen.
3. Tap Automation to open the automation interface.
4. Tap + in the top right corner.
   Here you can fill in different options to create an automation.
5. Tap Save.
   The new automation appears in the automation interface.

Removing the product from the app

1. Open the sensor interface.
2. Tap the pencil icon in the top right corner.
3. Tap Remove Device.

Nedis BV
De Tweeling 28, 5215 MC 's-Hertogenbosch
The Netherlands

06/20