MADOTI LUNA Assembly Instructions Manual page 11

Step 5
After ensuring that each rod and each board is correctly inserted into their respective pegs, always keeping the
LUNA resting on a mat, insert the screws into the holes. CAUTION!!Do not tighten the screws all the way in before
each one is in place. Do the same on the opposite side, always keeping the side of the LUNA on the ground.
Step 6
When all screws are in place, place the LUNA upside down in the 'BRIDGE' position and tighten them again, this
time all the way. Fix the cover caps over the fully tightened screws
WARNING! Check the soundness of the structure before each use and contact the manufacturer imme-
diately if any anomalies are found.
The supervising adult must also check that
-The components of the product are not damaged and are dangerous;
-Check that the product is clean and if necessary clean it (see Cleaning and storage).
THE MANUFACTURER CANNOT UNDER ANY CIRCUMSTANCES BE HELD LIABLE FOR ACCIDENTS OR
DAMAGE RESULTING FROM THE INAPPROPRIATE USE OF THE PRODUCTsl, AS WELL AS FROM THE
FAILURE TO COMPLY EVEN PARTIALLY WITH THE SAFETY REGULATIONS AND INTERVENTION PRO-
CEDURES DESCRIBED IN THE DOCUMENT.
EN