Beko FDIN Series User Manual page 33

Changing Warning Sound Volume
1. After turning on your machine, press
and hold the Time Delay and Start /
Pause / Cancel keys respectively.
2. Using the Time Delay key, turn on 9
and 6 LEDs.
3. Adjust the volume with the function
keys.
If the 1st programme indicator is on, the
volume is off
If the 2nd programme indicator is on, the
volume is at medium level
If the 3rd programme indicator is on, the
volume is at high level.
4. Turn off the machine with the On/Off
key to save the changes.
Floor illumination
Warning to show that machine is in
washing phase
(depends on the model)
Your machine reflects a light to the floor
during the washing process. This light turns
off after the washing process is complete.
Floor illumination is activated
automatically when the washing
programme starts and remains lit until
the end of the programme.
Floor illumination cannot be cancelled
by the user.
Inner Illumination
(depends on the model)
Some models have interior lighting to
illuminate the interior when the door is
opened.
Changing the interior lighting
setting
1. After turning on your machine, press
and hold the Time Delay and Start /
Pause / Cancel key for 3 seconds.
2. Press the Time Delay key to switch the
delay indicator to position 9.
3. You can press the function keys to
turn on and off the inner illumination.
The inner illumination is switched to
off position if the 1st programme LED
is on, and to the on position if the 2nd
programme LED is on.
4. Press the On/Off key to exit the
settings menu. Your setting will be
saved automatically.
SelfDry
(Depends on the Model)
Thanks to the "SelfDry" feature on your
machine, the drying effectiveness of your
machine is improved and power is saved.
There are two options, namely "OFF" and
"ON".
You may use sub-menu settings to change
"SelfDry" settings.
When you activate this function, the door
of your machine is opened automatically at
the end of the washing cycle.
SelfDry feature opens the door at
the end of the washing cycle thanks
to the "door opening shafts". This
process takes about 2 minutes. Do not
force to close the door if the power is
interrupted while the shafts are moving
out. Operation shall be completed
and shafts shall be retracted when the
power is restored.
SelfDry function may cause changes to
the cycle time.
33/EN