Connection of the FlexyMike Bluetooth Transmitter (FMK03)
1. BASIC OPERATING INSTRUCTIONS
Our models FMK03 (http://www.speechware.be/en/verArticulo.php?id=1671) --and FMK04-- feature a
couple of Light Emitting Diodes (LEDs), which lights up in Blue
the following meaning:
• • • •
B-LED
flashing twice quickly every 2 sec.: Power On and "Standby" (low consumption) mode
• • • •
B-LED
flashing once slowly every 2 sec.: "Link" (transmission) mode
• • • •
B-LED/R-LED
flashing alternatively: "Pairing" mode to establish a connection for the first time
• • • •
R-LED
flashes quickly (while using it): Low battery mode
• • • •
R-LED
lights on: Charging mode
• • • •
R-LED
flashes twice quickly and stops: Power Off mode.
2. INSTALLATION OF FULL DUPLEX BLUETOOTH TRANSMITTER (FMK03) UNDER
WINDOWS VISTA OR WINDOWS 7 (WITHOUT ANY THIRD PARTY SOFTWARE)
a) Put the FlexyMike Bluetooth Transmitter in "Pairing" mode (check above): press the On/Off
button for about 5 s. and until the
press the On/Off button, the Transmitter is Off.
b) Check for the Bluetooth icon of your Windows bar (in the bottom right hand corner of your screen):
If you cannot see it, then Bluetooth may be disabled. To enable it, select Start > Control Panel >
Wireless Assistant and press enable ("Allumer") Bluetooth in your computer:
under Windows Vista or Windows 7
(without any other third party software!)
B-LED/R-LED
(B-LED)
and Red
flash alternatively. Make sure that before you
(R-LED)
colour, with
Need help?
Do you have a question about the FlexyMike FMK03 and is the answer not in the manual?
Questions and answers