Terminal Block Connections; Initial Configuration - Via A Local Console - Nice Linear LNVR1-08P User Manual

Terminal Block Connections

The terminal block pinouts is shown as follows:
The relay pins default status is set to Normally Open� Connect your relay or external devices'
signal wires to the system, the system will automatically detect the current signal status� You can
then trigger the external devices using the DI/DO panel on the live view�
You can also configure the system alarm setting for the system to automatically trigger a relay pin
on the occurrence of system events� See Settings - Alarm - Events,
Normally Open
pin
Coil
Common pin
1
2
3
4
5
6
7
8
The GND are common ground for the DIs�

Initial Configuration - via a Local Console

A local console requires the following:
1� A monitor is connected via an HDMI or VGA cable�
2� A mouse and/or a keyboard are connected to the system�
3� It is presumed that the system has not been configured yet�
4� The system will prompt you to create a password�
20
Normally Closed
pin
Relay_NO
Relay_COM
DI1
DI2
DI3
DI4
ssss
GND
GND
page 109�