Cobra Marine MR HH400 EU Owner's Manual page 22

Advanced Operation
Operating Your Radio
Channel Scan
Scanning
During Channel Scan, the radio will rapidly switch from
channel to channel through all the channels. Whenever
any activity is detected, the radio will stop the scan for ten
88 30
seconds to allow you to listen briefly on that channel. It will
then continue to scan unless you switch out of the Scan mode.
75 60
NOTE
The radio must be squelched for the channel scan
to function. See page 31 for squelch procedure.
To enter channel scan:
Scan Button
1. From Standby mode, press the Scan button.
The radio will immediately begin to scan the entire
channel map selected in the active channel map.
The Scan icon will show on the LCD.
To exit channel scan:
1. From Scan mode, press the Scan button.
This will return the radio to Standby mode
Scan Icon
on the last scanned channel.
During channel scan (while receiving an incoming
transmission), you can choose from the following:
a. Press the Talk button to remain on that channel
and end scanning. This will return the radio to
Standby mode.
b. Press the Channel Up or Channel Down button
Talk or Channel Up/Down to resume scanning channels.
If you do not press any buttons within ten seconds,
your radio will automatically resume scanning channels.
During channel scan (while not receiving a
transmission), you can choose from the following:
a. Press the Talk button to communicate on the last
a b
memory location scanned and return to Standby mode.
b. Press the Channel Up or Channel Down button to
change scan direction.
40 English
Advanced Operation
Operating Your Radio
Memory Location Scan
Memory Location Scan
During Memory Location Scan, the radio will rapidly switch
68
69
from memory location to memory location. Whenever any
activity is detected, the radio will stop the scan for ten
71
79
seconds to allow you to listen briefly on that memory
A
location. It will then continue to scan unless you switch
72
78
out of the Scan mode.
A
NOTE
The radio must be squelched for the memory location
scan to function. See page 31 for squelch procedure.
NOTE
If there are fewer than two memory locations
programmed in the radio, the memory location
scan option will not be available. To program at
least two memory locations, see page 39.
Nothing comes close to a Cobra 41
®