Amana AGR6303MMW Installation Instructions Manual page 15

2. Remove the cap from the gas pressure regulator using
a flat-blade screwdriver.
NOTE: Make sure sealing washer remains in the same
position.
3. To convert to Natural gas, unscrew the plastic adjustment
screw by hand, turn it over, and screw it in again.
Inlet pressure
to Propane gas
180�
A. Cap
B. Sealing washer
C. Adjustment screw
4. Reinstall the cap.
To Convert Surface Burners
1. Remove burner grate, burner caps and burners.
A
B
A. Burner cap
B. Burner
A
A. Cap
Inlet pressure
to Natural gas
A
B
C
2. Locate the Propane gas orifice spuds for top burners in
the bag containing literature included with the range. Two
Natural gas spuds are stamped "149", one is stamped "110,"
and one is stamped "165."
3. Remove the Propane gas orifice spuds using a 7 mm (9/32")
combination wrench.
4. Install the Natural gas orifice spuds using a 7 mm (9/32")
combination wrench.
A. Spud
B. Holder
NOTE: The range cooktop is equipped with 4 burners: 1 burner
is power (left front), 2 burners are standard (right front and left
rear), and 1 burner is simmer (right rear).
A. Standard burner - Natural gas orifice spud number 149
B. Power burner - Natural gas orifice spud number 165
C. Simmer burner - Natural gas orifice spud number 110
D. Standard burner - Natural gas orifice spud number 149
5. Place Propane gas orifice spuds in the parts bag for future
use and keep with the bag containing literature.
6. Reinstall burners, burner caps, and burner grates.
A
B
15