Panasonic NV-DS65 Operating Instructions Manual page 49

≥Even if Playback Digital Zoom Functions are
being used, images that are output from the DV
Terminal (l 7) or Digital Still Picture Terminal
(l 37) are not enlarged.
≥As you enlarge an image, the quality of image
suffers.
ª Audio Dubbing
≥The blank section of a tape cannot be dubbed.
≥Sounds sent through the DV Terminal cannot be
dubbed.
≥If a tape has a non-recorded portion when the
tape is dubbed, images and sounds may be
disturbed when this portion of the tape is played
back.
≥If you set the tape counter back to 0 at the
position where you want to stop Audio Dubbing
so as to make it possible to use the Memory
Stop Function (l 57), Audio Dubbing is
terminated automatically when the tape reaches
this position.
≥In the case of importing data recorded with
Audio Dubbing to a PC using the PC's software
programme, only the original sound (ST1) may
be imported, depending on the software
programme.
ª Recording the Contents of Other
Equipment
Analog-Digital Conversion
≥When the Movie Camera is connected with other
digital video equipment through its DV Terminal,
images recorded in analog form from other
external equipment can be output to the digital
video equipment through the DV Terminal.
ª Using the DV Cable for Recording
(Digital Dubbing)
≥Regardless of the setting, digital dubbing is
carried out automatically in the same audio
recording mode as that of the Cassette on the
playback-side.
≥The images on the monitor of the recording side
may be disturbed, but it does not affect the
recorded images.
≥Even if Playback Digital Effects or Playback
Digital Zoom Function have been used, these
effects are not output from the DV Terminal.
≥Even if you use device equipped with DV
Terminals (such as IEEE1394), you may not be
able to perform Digital Dubbing in some cases.
≥Do not connect both an S-Video Cable or AV
Cable and a DV Cable.
ª Recording on a Card
≥You cannot record still images from the tape to
the Card when a USB Cables is connected.
≥The sound cannot be recorded.
≥The Shutter Effect cannot be used.
≥Pictures with wide-screen format signals cannot
be copied.
≥Even if Playbak Digital Effects (MIRROR,
MOSAIC, SEPIA, B/W) have been used, these
effects do not affect the recording.
≥Multi-Picture cannot be recorded.
ª Playing Back a Card
≥If a blank (nothing recorded) Card is played, the
screen becomes white and the [NO PICTURE]
Indication appears.
≥If you attempt to play back a still picture recorded
in a different format or a picture whose image
data is defective, the [INCOMPATIBLE IMAGE]
Indication could appear as warning.
≥This Movie Camera can also play back the
Mega-Pixel still pictures recorded with the other
equipment. However it takes longer than usual
time.
≥When the size of the picture played back is over
[1280k960], the picture played back in small
size on the LCD Monitor.
ª Photo Title
≥The Photo Title Function and Digital Function
cannot be used simultaneously.
≥After recording, the Photo TItle setting is cleared
automatically.
≥The Photo Title Function cannot be used when a
DV Cable is connected.
ª Formatting a Card
If a Card becomes unreadable by the Movie
Camera, formatting it may make it reusable.
Formatting erases all the data recorded on a
Card.
≥When the formatting is completed, the
[NO PICTURE] Indication appears.
≥It may not be possible to use the Card which was
formatted using this Movie Camera on another
unit. In this case, format the Card on the unit
which will be using the Card. Take steps to
ensure that valuable pictures are stored on the
personal computer, etc. as well before
proceeding.
ª DPOF
≥Perform the DPOF Settings with your own Movie
Camera in use.
≥Verifying the DPOF Settings may take a little
time. Wait until the [ACCESS] Lamp goes out.
ª Using a Card in a Personal
Computer
≥To erase pictures that you recorded on the Card
by using the Movie Camera, be sure to erase
them on the Movie Camera, not on the
computer.
49