Husqvarna Aspire T28-P4A Operator's Manual page 352

• Use protective boots with steel toe-cap and non-slip
soles.
(Fig. 24)
• Use clothing made of a strong fabric. Always use
heavy, long pants and long sleeves. Do not use
loose clothing that can catch on twigs and branches.
Do not use jewelry, short pants or sandals. Do not
go with bare feet. Put your hair up safely above
shoulder level.
• Keep first aid equipment near.
(Fig. 25)
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
In this section the product's safety features, its purpose
and how checks and maintenance should be carried
out to ensure that it operates correctly. See instructions
Introduction on page 347 to find
under the heading
where these parts are located on your product.
The life span of the product can be reduced and the risk
of accidents can increase if product maintenance is not
carried out correctly and if service and/or repairs are not
carried out professionally. If you need further information
please contact your nearest servicing dealer.
WARNING:
defective safety components. The product's
safety equipment must be inspected and
maintained as described in this section.
If your product fails any of these checks,
contact your service agent to get it repaired.
CAUTION:
All servicing and repair work
on the machine requires special training.
This is especially true of the machine's
safety equipment. If your machine fails
any of the checks described below you
must contact your service agent. When
you buy any of our products we guarantee
the availability of professional repairs and
service. If the retailer who sells your
machine is not a servicing dealer, ask him
for the address of your nearest service
agent.
To do a check of the user interface
The green LEDs (A) show the battery status when the
product is on but not in operation.
1. Press and hold the on/off button (B). (Fig. 26)
a) The product is on when the green LEDs (A) are
on.
352
Read the warning
Never use a product with
b) The product is off when the green LEDs (A) are
off.
Troubleshooting on page 358 if the warning
2. Refer to
indicator (C) comes on or flashes.
To do a check of the power trigger lockout
The power trigger lockout prevents accidental start.
When you push the power trigger lockout (A), it releases
the power trigger (B). When you release the handle, the
power trigger and the power trigger lockout move back
to their initial positions.
(Fig. 27)
1. Make sure that the power trigger is locked when the
power trigger lockout is in its initial position.
(Fig. 28)
2. Push the power trigger and make sure that it moves
back to its initial position when you release it.
(Fig. 29)
3. Make sure that the power trigger and the power
trigger lockout moves freely and that the return
spring works correctly.
(Fig. 30)
4. Start the product. Refer to
page 356 .
5. Release the power trigger and make sure that the
cutting attachment stops fully.
To do a check of the cutting attachment guard
WARNING:
attachment without an approved and
correctly attached cutting attachment guard.
Always use the recommended cutting
attachment guard for the cutting attachment
that you use, see
page 360 . If an incorrect or faulty cutting
attachment guard is attached, it can cause
serious personal injury.
The cutting attachment guard stops objects that eject
in the direction of the operator. The cutting attachment
guard also prevents injuries that can occur if you touch
the cutting attachment.
1. Stop the motor.
2. Do a visual check for damages, for example cracks.
3. Replace the cutting attachment guard if it is
damaged.
To start the product on
Do not use a cutting
Technical data on
1885 - 004 - 22.09.2022