Advertisement
3
1
Pivot-Pin
2
Move the clamp with hook to your desired position.
The hook can be positioned anywhere you want, but you
must place it to just beside the pillar when you choose
K-style leg.
To move the clamp, loosen ① clamp tighitening bolt and
② pivot-pin fixing bolt together with M5 hex wrench, then
③ slide the clamp along the pillar.
The clamp may not move if you loosen the side
!
bolt only. You should loosen both bolts.
Be sure the clamp touches the pillar directly. If
!
you don't loosen the bolt enough, it may cause
scratching.
When you set the legs in K-style, you must
!
place the hooks just beside the pillar, otherwise
the stand may tip over due to improper balance.
Adjust the bottom hooks clamp height as the bike becomes
vertical when hooking the rear tire in the deepest position.
After moving, firmly tighten both ① and ② bolts.
About Top Hook
!
The Top Hook is covered by black Vinyl tube. This works
to protect the wheel rim surface from scratching problem
while hanging from the hook.
Please note, this Vinyl tube may possibly stick to a rim/
wheel decal or carbon wheels, especially. This could be
caused by room temperature or extended storage time.
This issue can be avoided by removing the Vinyl tube
and using a single sided tape in place of the Vinyl tube.
Minoura is not responsible to any damage the Vinyl tube
may cause to your wheels or bicycle.
Pivot-Pin Fixing Bolt
3
Clamp Tightening Bolt
(Fig. R)
How To Reinstall Clamp Band
The clamp bands come pre-installed and they should not
need to be removed. However, there may come a time when
adding options to your P-600AL-6S that you will need to
remove them.
Install the clamp peoperly as instructed below.
Failure to do so may cause parts damage or may cause the
bike to come off the stand..
1
Wind the clamp arms around
the Pillar.
The following description is
set as the single side arm is on
YOUR right, and the double
side arm is on YOUR left.
2
Put the Pivot-Pin through all 3 holes
on the clamp band from bottom side,
and screw the Pivot-Pin Fixing Bolt
with a flat washer temporarily.
Make sure to insert the
!
Pivot-Pin from the bottom.
If you don't, you will not
be able to tighten the bolt
using a hex wrench.
Do not tighten the Pivot-
!
Pin Fixing Bolt firmly yet.
The next job will become
difficult.
3
Turn the Pivot-Pin to align the thread
hole to the side hole on the clamp
band.
Screw the Clamp Tightening Bolt into
the Pivot-Pin.
To fix the clamp band firmly, tighten
the Clamp Side Pin first then tighten
the Pivot-Pin Fixing Bolt later.
- 6 -
Pillar
(Fig. S)
(Fig. T)
5 N.m
(Fig. U)
Advertisement
