Advertisement
4
Attach the legs to the Lower Pillar.
All 4 legs are exactly the same.
One end has a reinforcement bracket inside in
order to avoid deforming the tube when the bolt is
tightened. (see Fig. D)
Make sure if this bracket is fully inserted into the
tube. If it is missing, do NOT use and contact the
shop you purchased this product immediately.
If the bracket
!
has been set in
wrong position,
align the bolt
hole on the leg
and the bracket.
5
Place the legs in the shape of "K" and sandwitch
them, Top to Bottom Plates then fix them by 8
M6x50 Bolts. (Use the holes indicated in black dots
in Fig. E)
Put the bolt to the Leg from upper side, and tighten to
the thread hole with 6 N.m torque. (see Fig. F)
Bottom Plate
Reinforcement
Bracket
(Fig. D)
(Fig. E)
!
Do not tighten just
one bolt.
Try to tighten each
bolt evenly.
M6x50 Bolt
M6 Spring Washer
M6 Flat Washer
(Fig. F)
- 3 -
Assemble P-600 in X-style Leg
Setting up the P-600 in the X-style allows the stand to be
placed anywhere due to the larger footprint and maximum
stability of the X.
It also allows you to install extra optional attachments on
the pillar.
Please note, setting the stand up in the X-style does
require more floor space.
1
There are two square plates in the kit.
Know that while both plates look similar, they are
different.
The plate for the upper side has larger holes to allow
the bolts come through, and there are 4 holes in the
center area to be connected with the Lower Pillar.
Another plate is for the lower side and the hole sizes
are smaller than the upper plate. And also there is no
hole in the center area.
Make sure the hole layout is not symmetric. The side
with in-line 4 holes must face to the back side.
(see Fig. G)
Top Plate
This side with in-line 4 holes is for the back side
2
Confirm the direction of the Lower Pillar.
Check the dimension of the pillar shown in Fig. B.
If the C-shaped slot is threaded, it is the bottom side
(for the side of the legs). If not, it is the upper side.
(The top end of the Upper Pillar has a plastic cap)
3
When assembling the Legs in K-shape, the direction
of the Lower Pillar is precisely fixed. however, the
pillar direction is not fixed at all when assembling in
X-shape.
Install the Bottom Plate to the Lower Pillar by
screwing M6x30 Bolts to the 4 holes in the center
section as shown in Fig. I.
Tighten the bolts by the supplied 5mm hex wrench at
4 N.m torque.
Bottom Plate
(Fig. G)
(Fig. H)
Advertisement
