Bissell POWERFRESH 19405 Series User Manual page 8

Operations
Cleaning Hard Floors
Your PowerFresh® Steam Mop is designed to
clean hard flooring such as ceramic tile, laminate,
marble, stone, and sealed hard wood floors. Use
of your PowerFresh Steam Mop on waxed or
some unwaxed floors may result in a diminished
glossiness. PowerFresh Steam Mop is not for
use on unsealed wood floors. For best results
test in an inconspicuous area and check the care
instructions from your flooring manufacturer.
1. Plug the machine in and wait 30 seconds for
it to heat up. Choose the level of steam to clean
your floor: Low (delicate floors), Medium (regular
cleaning), High (durable floors or sticky messes).
Begin cleaning by slowly passing the machine
over the floor surface.
2. For best results to sanitize* an area of your
floor, use the microfiber cloth pads and slowly
and evenly move your steam mop back and
forth at least three times over the area. Remove
and the pad after use and wash.
3. To thoroughly clean dried-on sticky spots
place the scrubby pad on the steam mop. Then
press and lock the Easy Scrubber brush into
place and slowly move the brush over the sticky
spot to remove.
4. To turn OFF the PowerFresh Steam Mop,
continue to press the Steam Level button until
the blue light is illuminated above the Steam
Level button.
5. When the PowerFresh Steam Mop
stops emitting steam, unplug the machine.
Simply remove the water tank, refill and
continue steaming.
*Using the microfiber pad, use as instructed. Results may vary. Tested under controlled laboratory conditions.
8
www.BISSELL.com
WARNING
Never put descaling, alcoholic or detergent products
into the steam cleaner, as this may damage it or make
it unsafe for use.
WARNING
Tinted plates on foot may get hot while steam mop is
in use. Do not touch while hot.