Advertisement
This device is intended only for OEM integrators under the following conditions:
1)
The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2)
The transmitter module may not be co-located with any other transmitter or antenna,
3)
For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band
by supplied firmware programming tool. OEM shall not supply any tool or info to the end-user regarding to
Regulatory Domain change.
As long as 3 conditions above are met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements required
with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer considered
valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
End Product Labeling
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such that 20
This transmitter module is authorized only for use in device where the antenna may be installed such that 20
cm may be maintained between the antenna and users.
cm may be maintained between the antenna and users. The final end product must be labeled in a visible
FCC compliance requirements are met.
following: "Contains FCC ID: VQFRT3572".
area with the following: "Contains FCC ID: VQF-RT3572".
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user's manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this manual.
The grantee's FCC ID can be used only when all FCC compliance requirements are met.
The grantee's FCC ID can be used only when all
The final end product must be labeled in a visible area with the
Advertisement
