Using Homelink - Lucid Air Owner's Manual

To set up a new HomeLink program, have the
remote for the garage door or gate you are
programming ready, and follow these steps:
1. On the Pilot Panel, select
Connectivity > HomeLink, then
press + ADD NEW HOMELINK.
Note: Press CANCEL during any step
of programming to return to the main
HomeLink® screen. No information will
be stored.
2. Use the on-screen keyboard to enter a
name for your HomeLink®, then press
CONTINUE.
3. Prepare your surroundings as instructed
on the screen, and press CONTINUE
when you are ready to proceed.
Note: Select Program with D-Mode
only if your device requires D-Mode
programming per the HomeLink website
or operator's manual.
4. To record the remote signal, press and
hold the remote 2 in (5 cm) below the
letter L on the front of your vehicle
until the horn sounds and the headlights
flash.
5. Once the Pilot Panel shows
that recording is completed, press
CONTINUE.
Note: If the on-screen process detects
that your device uses a fixed code, it will
automatically skip this step and proceed
to the test in the next steps.
6. To train the receiver, press the LEARN
button on the back of your receiver
(removing the cover if needed), then
press CONTINUE on the Pilot Panel.
Note: Because pressing the LEARN
button is time-sensitive, a second
person can assist with this step.
Note: If your receiver is QuickTrain
compatible, you can press CONTINUE.
Note: After pressing the 'LEARN' or
sync button, you will have 30 seconds
to test HomeLink. If a signal is not
detected within the timeout period, an
error message will be displayed with the
option to try again.
7. To test, press the TEST HOMELINK
button. You will need to press this three
Infotainment
>
8. During each brief test, the TEST
9. After a test completes, a check replaces
10. After all three tests have completed,
11. If you pressed YES, you will be brought
Reprogramming a device
1. On the Pilot Panel, select
2. On the device details screen, press
3. Follow the steps for programming a
Using HomeLink®
Once devices have been programmed to your
vehicle, they can be accessed using the
HomeLink menu on the right Cockpit Panel.
The HomeLink menu will open automatically
when the vehicle is detected within 82 ft
(25 m) of a programmed garage door or gate.
To access it manually:
1. Press the status bar to expand.
2. Press
times in total. Wait until you see a
check mark before pressing the button
a second and third time.
HOMELINK button will be temporarily
unavailable, while the current test
number animates to indicate it is in
progress.
Note: The device you are programming
may respond during any of these three
tests. Continue with all three tests.
the number and the TEST HOMELINK
button becomes available. Continue
through all three tests.
the screen will prompt you to confirm
whether the device responded. Press
YES or NO.
Note: Pressing NO will give you the
option to restart the test and contact
information for HomeLink Help.
back to the Connectivity screen. Your
new HomeLink device will be listed
under CONNECTED DEVICES.
Connectivity > HomeLink, then
select the device to be reprogrammed.
PROGRAM.
device. See Programming
to open HomeLink.
>
Homelink.
139