Subscribe to Our Youtube Channel
Related Manuals for ISANTA SENCO SLS15Mg
Summary of Contents for ISANTA SENCO SLS15Mg
- Page 1 SLS15Mg SLS18Mg Finish Stapler Instructions Warnings for the safe use of this tool are included in this manual.
-
Page 2: Safety Warnings
sAFEty WARNiNGs EMployER’s REspoNsibilitiEs Warning! Employer must enforce compliance Read and understand tool labels with the safety warnings and all other and manual. Failure to follow instructions which accompany this tool as shipped from the manufacturer. warnings could result in DEATH or SERIOUS INJURY. - Page 3 sAFEty WARNiNGs sAFEty WARNiNGs Do not connect tools to air pressure Drive fasteners into work surface that potentially exceeds 200 psig only; never into materials too or 13.7 bar. hard to penetrate. 200 psig 13.7 bar Air compressors used to supply compressed air to this tool must comply with requirement ANSI/ Do not drive fasteners on top of...
- Page 4 tool usE tool usE These tools have an adjust- able trigger and can be set for Read section titled “Safety Warn- Contact Actuation ( ) or ings,” before using tool. Sequential Actuation ( With a “Contact-Actuation” to load: (Dual-Action) trigger, nails can be driven two ways: Depress latch and slide rail open..
- Page 5 tool usE tool usE These tools have an adjust- should a staple jam occur: able trigger and can be set for Disconnect air supply. ) or Contact Actuation ( Sequential Actuation ( With a “Contact-Actuation” (Dual-Action) trigger, nails can be driven two ways: Depress latch and slide rail open.
-
Page 6: Maintenance
MAiNtENANCE WARNiNG Repairs other than those described here should be per- formed only by trained, qualified personnel. Read section titled “Safety Warn- ings” before maintaining tool. All screws should be kept tight. Loose screws result in unsafe operation and parts breakage. With tool disconnected, make daily inspection to assure free movement of safety element... -
Page 7: Troubleshooting
tRoublEsHootiNG A = Parts Kit # YK0780 syMptoM ACCEssoRiEs Air leak near top of tool / Sluggish operation. SENCO offers a full line of solutioN accessories for your SENCO tools, Verify air supply / Tighten screws or including: install Parts Kit A . Air Compressors Hose Couplers... -
Page 8: Technical Specifications
SLS15Mg Stapler SLS18Mg Stapler Drives 18 Gauge, SENCO L Style, Drives 18 Gauge, SENCO L Style, 1/4” Crown Staples 1/4” Crown Staples MoDEl: 1V0021N MoDEl: 1W0021N tECHNiCAl spECiFiCAtioNs Minimum to maximum operating pressure 70–120 psi 4.8–8.3 bar 70–120 psi 4.8–8.3 bar Air Consumption (60 cycles per minute) 2.067 scfm 58.5 liter/min.
Need help?
Do you have a question about the SENCO SLS15Mg and is the answer not in the manual?
Questions and answers