Page 1
The installation area Install the appliance in areas: ■ specific for this purpose and compliant for cooking industrial foods; ■ that are adequately ventilated; ■ that comply with the laws in your country regarding system safety/ safety in the workplace; ■...
Page 2
Do not install the appliance near: ■ other appliances that reach high temperatures; ■ easily flammable or heat-sensitive materials, walls or furniture.
Page 6
A The appliance is supplied with an IEC320 C13 power cable To connect up the electrics, insert the power cable fully into the IEC320 C14 connector on the back of the appliance.
Page 7
HOT VACUUM connected to an external compressor Connect the plug on the external compressor to the socket; set the external compressor switch to “ON”.
Page 14
Place the VACUUM.20 or VACUUM.40 tray on the surface and cover with the VACUUM.LID. Make sure the lid is properly inserted on the tray and does not move. Take the sleeve and place the suction pad over the lid valve. The suction pad must cover the valve without touching it and must...
Page 15
Once the suction pad has been correctly positioned, press the button on the main unit to start the suction cycle. The vacuum packing process takes about 1 minute, during which the LED flashes green. The sleeve does not need to be held still as it remains firmly attached to the lid.
Page 16
Wearing rubber gloves and goggles, spray UNOX SPRAY&RINSE on the steel parts. Do not spray the product on the suction pad as this may cause damage over time. ■ Leave the detergent to act for at least 10 minutes. ■ Remove softened residue with a soft sponge.
Page 17
Fill a 100 mm high VACUUM.20 GN1/2 tray with 1.5 l of water and 1 teaspoon of a dishwashing detergent that does not create excessive suds. Immerse the sleeve in this detergent solution, holding it at an angle so that the suction pad is immersed in water;...
Page 18
Replace the cleaning solution in the tray with 1.5 litres of clean water; Perform at least 2 rinse cycles, pressing and holding the button for 5 seconds to start a cleaning cycle. Replace the water after each rinse cycle until all the detergent has been removed.