Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Target Blu Eye 2
Summary of Contents for Target Blu Eye 2
- Page 1 INSTALLATION MANUAL | TARGET BLU EYE 2 Know what’s out there...
-
Page 2: Table Of Contents
CONTENTS IN THE BOX INSTALLATION SEQUENCE WITH LED DISPLAY CHECKING SUITABILITY OF MIRROR GLASS FOR LED DISPLAY MOUNTING LED DISPLAY IN REAR VIEW MIRROR CONNECTING AND PLACING MICROSWITCHES AND DISPLAY CABLE INSTALLING FIRMWARE ACTIVATE ‘INSTALLER MODE’ LOCATION FOR THE ANTENNA EXIT ‘INSTALLER MODE’... -
Page 3: In The Box
IN THE BOX • Target Blu Eye 2 receiver • LED display for mounting in the rear view mirror (including 2 micro switches and connection cable) • LCD display • VCD dipole antenna for invisible mounting behind front or rear bumper •... -
Page 4: Installation Sequence With Led Display
INSTALLATION SEQUENCE WITH LED DISPLAY Check the suitability of the mirror glass for the led display: • After dismantling the rear view mirror, always first check whether the mirror glass allows enough light from the LED display to pass through. •... - Page 5 ext led usb display add on system1system2 S W I T C H B U S Illustration 1...
-
Page 6: Activate 'Installer Mode
After the firmware is installed; install the VCD dipole antenna using ‘Installer Mode’ . Proceed as follows: ACTIVATE ‘INSTALLER MODE’ • Connect the antenna to the antenna connector on the receiver. Switch on the car’s ignition; wait until the status LED of Blu Eye lights green. •... -
Page 7: Exit 'Installer Mode
• Fix the antenna permanently to the inside of the bumper. Use a 2-component sealant or thermal adhesive for this purpose and make sure the surface is dry and clean. Fix the antenna at least at the marked points as indicated by circles (see illustration 2). - Page 8 ANT - 2 ANT - 1 FRONT rear r r ear Illustration 2...
-
Page 9: Technical Specifications
TECHNICAL SPECIFICATIONS • Supply voltage: 10 - 16V. • Power consumption: maximum 550mA • Fuse: • Frequency range: 380 – 430MHz. • TETRA detection by means of ‘Waveform recognition’ , no decoding • Temperature range: -20°C - +50°C • Receiver dimensions: 137 x 114 x 32mm. - Page 10 Zuidergracht 21 | 3763 LS Soest | the Netherlands info@tracktechnologies.nl | +31 (0)35 760 5760 www.tracktechnologies.nl www.blu-eye.eu...