Features; Mounting The Device To A Rack Drawer; Minimum System Requirements - M-Audio FireWire Solo User Manual

Features

< Front panel balanced XLR mic input with switchable phantom power and dedicated gain control
< Front panel unbalanced guitar/instrument 1/4" input with dedicated gain control
< Switchable rear panel unbalanced 1/4" line inputs
< Rear panel balanced/unbalanced 1/4" TRS outputs with level control
< Rear panel coaxial S/PDIF I/O.
< Front panel headphone output with level control
< Versatile mixer/router control panel provides near zero-latency hardware direct monitoring.
< Extremely low-latency hardware/drivers.
< Kensington lock port for security
< Two 6-pin FireWire ports.
< Cool blue indicator LED.
< Bus-powered (six-pin FireWire connection required) or powered via included PSU.
< Frequency response from 20-40kHz
< Dynamic range of 102dB
< Supports sampling rates of 44.1k, 48k, 88.2k, and 96kHz

Mounting the device to a rack drawer

Holes are located on the left and right of the bottom of the FireWire Solo, to allow you to mount this device to a rack tray. The FireWire Solo is
mountable on either the left or right side of the drawer. If you choose to mount the device to a rack tray, you must first remove the rubber pads
from the base of the unit.

Minimum System Requirements

Windows
< Pentium III – 500 MHz or higher
< 128 MB RAM
< Windows XP (SP2) with DirectX 9.0b or higher
< Onboard FireWire connection or installed FireWire PCI card
The FireWire Solo is not supported under Windows 98, Windows ME or Windows 2000.
Mac OS
< Macintosh G3/G4* 500 MHz or higher
< OS X 10.2.8 or later, 256 MB RAM or
< OX X 10.3.5 or later, 512 MB RAM
< Onboard FireWire connection or installed FireWire PCI card
*G3/G4 accelerator cards not supported
OS X 10.3.5 or later required for Dolby Digital and DTS pass-through with Apple DVD player.
2