Advertisement
VacuFlush toilet with foot pedal
Toilet system start-up
1. Fill freshwater tank.
2. Turn on electrical power and water supply to toilet.
3. Flush water into toilet system by pressing foot pedal until water starts flowing
to the vacuum pump, about 15 seconds. The vacuum pump will run about one
minute until system reaches operating vacuum level and then will shut off .
Normal toilet operation
ADD WATER TO TOILET BOWL
Raise foot pedal until desired water level is reached. More water is
usually added only when flushing solids. (If pedal is pressed too long,
water may overflow the toilet bowl.)
FLUSH TOILET
Press foot pedal sharply down until contents clear bowl. (A popping
noise is normal when the vacuum seal is broken.) Hold foot pedal for
three seconds. After flush, let foot pedal snap back into position. If
foot pedal is accidentally released before waste clears bowl, do not
flush again until vacuum pump stops running. A small amount of
water remains in bowl after flushing.
For system with VacuFlush status panel, flush only when the green
"OK to Flush" light is on. Toilet will not flush until the green light is on. It takes about
one minute for vacuum to recharge for the next flush.
If the red "Do Not Flush" light is on, the system is either recharging the vacuum, or
the holding tank is full. Do not attempt to flush the toilet during these conditions, or
a clog may occur in the toilet system.
For complete information, see your VacuFlush owner's manual, or call Dometic Corp., Product Customer Service at 1-800-321-9886.
VacuFlush
Toilet System Quick-Start Guide
®
DO NOT FLUSH FOREIGN OBJECTS
CAUTION! Flush only water, bodily wastes and rapid-dissolving
tissue paper. Do not flush wet wipes, sanitary napkins, condoms,
diapers, razor blades paper cups, cotton swabs food, hair or
liquids such as oils or solvents. Clogging or damage to the toilet
system may occur.
Note
Make sure all guests understand toilet operation before use.
VacuFlush toilet with electric flush switch
Toilet system start-up
1. Fill freshwater tank.
2. Turn on electrical power and water supply to toilet.
3. Flush water through entire toilet system by flushing toilet five times (press Flush
switch and allow each flush cycle to complete until green light indicates system is
ready for next flush). Each cycle takes about one minute.
Normal toilet operation
ADD WATER TO TOILET BOWL
Press "Add Water" switch until desired water level is achieved. More
water is usually added only when flushing solids. (If switch is pressed
too long, water flow will shut off automatically to avoid overflow.)
FLUSH TOILET
Press "Flush" switch down for a moment, then release it. Flush only
when the green "OK to Flush" light is on. Toilet will not flush until the
green "OK to Flush" light is on.
It takes about one minute for vacuum to recharge for the next flush.
If the red "Do Not Flush" light is on, the system is either recharging the
vacuum, or the holding tank is full. Do not attempt to flush the toilet
during these conditions, or a clog may occur in the toilet system.
Advertisement
