Related Manuals for Water HP02
Summary of Contents for Water HP02
- Page 1 Installation Guide HP02 SYSTEMS Thank You for Your Purchase! Questions ? Please contact Water, Inc. Service Department 1-800-322-9283 We will be glad to assist you! Water, Inc 7 04 Kingshill Place Carson, CA 90746...
- Page 2 • 1054 Preloaded tank (Varies on models) • Neoprene cover or Chrome sleeve for tank protection JOB SPECIFICATION SHEET Model Number: _________________________________________________ Water Hardness: _______________________________________ ppm or gpg Capacity Per Unit: _______________________________________________ Mineral Tank Size: ______________ Diameter: ________ Height: _________ Salt Setting per Regeneration: _____________________________________ 1.
- Page 3 This product should be installed by a professional plumber. • This unit is designed to be installed on potable water systems only. This product must be installed in compliance with all state and municipal plumbing and electrical codes. Permits may be required at the time of installation.
- Page 4 Location Drain You must have an air gap on the drain line to prevent back flow of drain water into the system. A 2x the drain line pipe diameter air gap is required with a minimum 1" air gap.
- Page 5 7. Make sure that the floor is clean beneath the salt storage tank and that the tank is level. 8. On units with a bypass, place in bypass position. Turn on the main water supply. Open a cold soft water tap nearby and let run a few minutes or until the plumbing is free from foreign material (usually solder) that may have resulted from the installation.
- Page 6 If the system is metered, verify that it is measuring flow by running the Control Type has been set to service water and watching for the flow indicator on the display. If the Day-of-Week). unit does not measure flow, verify that the meter cable is connected properly and that the meter is functioning properly.