Using The Smartclick Styler - Philips NORELCO 7700 Manual

ENGLISH
22
C
Insert the raised notch of the shaving unit
9
into the slot in the top of the shaver. Press
the shaving unit down to attach it to the
shaver. You will hear a 'click'.
C
Place the shaver in the SmartClean System
10
to protect the heads.

Using the SmartClick Styler

C
1 Pull the shaving unit straight off the shaver.
NOTE: Do not turn the shaving unit while you
pull it off the shaver.
C
2 Insert the raised notch of the SmartClick
styler into the slot in the top of the shaver.
Press the styler down to attach it to the
shaver. You will hear a 'click'.
Styling with Comb Attachment
◗ Use the SmartClick styler with the comb
attached to trim your beard and moustache.
◗ To prevent trimming your beard and
moustache too short, make sure your hair is
dry.
◗ Always comb beard and/or moustache with a
fine comb before using the styler.
◗ The hair length settings on the styler
correspond to the remaining hair length after
trimming. There are 5 settings from 3/64 in. –
3/16 in. (1-5mm).
C
Slide the comb straight into the guiding
1
grooves on both sides of the SmartClick
styler. You will hear a 'click'.
C
2 Press the length selector and push to the
left or right to select the desired hair
2
length setting.
To prevent accidentally trimming hairs too short,
start with the maximum setting of 3/16 in.
1
(5mm).
Turn shaver ON.
3
The shaver display shows the remaining battery
capacity.
C
Move the styler upward with gentle
4
pressure making sure the front of the
comb is in full contact with the skin.
NOTE: If cut hairs accumulate in the comb, turn
the shaver off, remove comb and blow and/or
shake hair out of the comb.
ENGLISH
23