Table of Contents
Advertisement
Product Specification and User Manual
RFID GEN3 System
Once the system is powered-up and the vehicle is started, the diagnostic tool can be used
to monitor whether conducted noise could be affecting the performance of the RFID
signal. The following documents can be used as a guidance for measurement or source
identification:
000001 FO-QA-029-KA Skidoo 600 ETEC Capacitor Grounding Return Problems
000002 FO-QA-029-KA RFID DESS Grounding Problems
000003 FO-QA-029-KA SKIDOO TUNDRA 600 ETEC Harness Problems
It is recommended to use an isolation transformer to power the Oscilloscope to avoid
ground noise signals that could affect the measurement.
8.3 Performance Criteria
It is recommended that no errors should be observed during the period of 1 minute (59400
transmissions) to validate that no perturbations could affect the RF performance of any
RFID GEN3 System.
CONFIDENTIAL
Page 33 of 34
Advertisement
Table of Contents
