Steren MP3-053 - Audio Transmitter with USB and MP3 Player Manual

Table of Contents

Contents

1 INTRODUCTION
2 CONTENT
3 TRANSMITTER PARTS
4 REMOTE CONTROL PARTS
5 HOW TO USE
6 SPECIFICATIONS
7 Documents / Resources
- 7.1 Download manual

INTRODUCTION

Before using your new Steren product, read this instruction manual to avoid any malfunction.

This product is not a toy; Keep out of children reach.
Do not use or store the product in dripping or splashing places.
Do not expose the equipment to extreme temperatures.
Do not use solvents or other chemicals to clean it.
Do not attempt to open the product. Contact the dealer if you have any questions.
Remember to operate your vehicle with caution and to give full attention during handling. Use the speakerphone or handsfree to answer a call while driving.

CONTENT

TRANSMITTER PARTS

Display
Previous song / Previous station *
Micro SD Card Slot
USB reader
Pause / Play / Change Playback Mode *
USB charging port 2.1A
Auxiliary input
Next song / Next station*

^*Hold down the button

REMOTE CONTROL PARTS

CH -: Lower frequency
CH +: Upload frequency
: Previous song
: Next song
: Play / Pause
+: Increase volume
-: Decrease volume
EQ: Changing EQ Effects
0 - 9 Song number / frequency
PICK SONG: Song selection (Press once and immediately press a number to change directly the song / frequency)
CH SET: Frequency selection (Press once and immediately press a number to change directly the song / frequency)

Replace Battery
Insert a battery type CR2025. Be sure to place it with the polarity as follows:

HOW TO USE

FM Synchronization

Connect the transmitter to the cigarette lighter of the car.
Tune to a free FM frequency on the stereo.
Press and hold or to select the same frequency on the transmitter.

Connection

Use the auxiliary cable to connect a device or insert a USB or micro SD memory card (with MP3 files) into the corresponding port on the transmitter.

Music Playback

If you have used the auxiliary connection, control the music playback from the device.
If you have inserted a USB / micro SD memory card, playback will start automatically; Use the buttons on the remote control or the transmitter to control playback.
If you have multiple devices connected simultaneously, press and hold the button to switch modes.

SPECIFICATIONS

Input: 12 V
USB input: 5 V 2.1 A
Transmission frequency range: 87.5 to 108 MHz
Operating temperature: 0°C to 50°C
Frequency response: 20 Hz to 15 kHz
Remote control: 3 V ~~- - -~~ (CR2025)