Advertisement
Blade Replacement Instructions
REPLACING THE BLADE:
1. Place the tool on a flat surface with screw heads
upwards.
2. Remove all the screws (See diagram)
3. Remove the top half containing the screws from
the lower half. You may need to "wiggle" the parts
to separate them. This will expose the blade.
MAINTENANCE:
For longer tool life, occasionally disassemble the AutoCutPL and clean away dirt, dust or other residue.
General Wire Spring Co,
1101 Thompson Avenue
McKees Rocks, PA 15136
412-771-6300
© General Wire Spring Co. 2020
AutoCut PL™
Close-up of blade
www.drainbrain.com
4. Very carefully remove the old blade using pliers.
Caution: Blade is sharp. Use extreme care.
5. Replace the blade by aligning the hole in the
blade with the peg on the bottom half of the tool
body.
6. Ensure the blade is aligned and seated correctly
in the pocket
7. Replace the top body of the tool by aligning the
pegs and holes.
8. Replace all the screws and tighten.
9. Your tool is ready for more plastic pipe cutting.
Set of 3 Replacement blades: Part # APB.
C-ATCPLOI-042020
Advertisement
