General Wire Spring AutoCut PL Operating Instructions

The compact, convenient AutoCutPL
makes clean, uncrushed, square cuts quickly – and with less effort. It fits in the palm of your hand.
Great for easy use in tight spaces, AutoCutPL
with less than one inch of clearance!
Do not insert fingers into the cutter. This could result in
significant injury.
OPERATION:
1.
Open the gate and remove the
blade guard. Save the blade
guard. Reinstall when the tool is
not in use.
2.
Place tool over tubing.
3.
Close gate until blade comes into
contact with the tubing.
MAINTENANCE:
For longer tool life, occasionally disassemble the AutoCutPL and clean away dirt, dust or other residue.
AutoCut PL™
Operating Instructions
Plastic Tubing Cutter
For PEX and CPVC-CTS
®
plastic tubing cutter is an easier way to cut plastic tubing. It
®
lets you cut both PEX and CPVC-CTS plastic tubing
4.
Rotate the tool in the direction of the arrows (on
the face of the tool) while you squeeze the gate.
5.
The tool must be turning as you make the cut or
you could damage the blade.
6.
Do not rotate the tool in the opposite direction or
you could damage the blade and the tubing.
7.
While rotating the tool, apply even pressure to
close the gate further as the blade cuts through
the wall of the tubing.
8.
Keep the tool squarely aligned as you continue to
rotate until the cut is complete.
9.
Release the gate and remove from the tubing.
10.
Replace the blade guard.
For instructions on how to replace the blade, turn
page over.