Advertisement
4. Timer
■ Timer functions are different by each remote controller.
■ For details on how to operate the remote controller, refer to the appropriate operation manual included with each remote controller.
4.1. For wireless remote controller (option)
ON/OFF
MODE
CHECK
TEST RUN
SET
5. Emergency Operation for Wireless Remote-controller (option)
HEAT
10
C
D
B
A
TEMP
FAN
AUTO STOP
13
VANE
AUTO START
LOUVER
h
2
min
RESET
CLOCK
AAA
AAA
ON/OFF
1
2
COOL
1) Set the current time
1 Press the CLOCK button using a thin stick and blink the time A.
h
min
2 Press the
and
button to set the current time.
3 Press the CLOCK button using a thin stick.
2) Set the time to start the unit as follows
AUTO START
1 Press the
button.
• Time can be set while the following symbol is blinking.
On time: B START is blinking.
• The start times is displayed at A.
2 Use the
h
and
min
buttons to set the desired time.
3 To cancel the ON timer, press the
3) Set the time to stop the unit as follows
AUTO STOP
1 Press the
button.
• Time can be set while the following symbol is blinking.
Off time: C STOP is blinking.
• The stop times is displayed at D.
h
min
2 Use the
and
buttons to set the desired time.
3 To cancel the OFF timer, press the
4) Changing the set times
Press the
or
to cancel the timer and repeat from 2) or 3).
AUTO START
AUTO STOP
1 ON/OFF lamp (lit when unit is operating; unlit when unit is not
operating)
2 Emergency operation
In cases where the remote control unit does not operate properly, use
either the
COOL or
HEAT button on the wireless remote control
signal receiver to toggle the unit on or off. On cooler only units,
pushing the
HEAT button toggles the fan on and off.
Pressing the
COOL or
HEAT button selects the following
settings.
Operation mode
Preset temperature
24 °C/75 °F
Fan speed
AUTO START
button.
AUTO STOP
button.
COOL
HEAT
24 °C/75 °F
High
High
Advertisement
