Advertisement
Quick Links
UK-EU
INSTALLATION GUIDE
ALUMINA TABLE LAMP
Thoughtful lighting, responsibly designed in London.
Thank you for making the switch to Tala.
Discover the full Tala family at tala.co.uk.
BEFORE STARTING
Please read instructions thoroughly before installation
and keep them for future reference. Please take
extreme care when dealing with electrical equipment.
IMPORTANT
Bulb must be installed in fixture before turning on.
WARNING
Incorrect assembly may result in risk of fire or electric
shock.
CARE AND CLEANING
We recommend cleaning with a soft dry cloth. Do not
use abrasive materials as these will damage the finish
of the product.
AFTER-CARE
Scan me for more
Please note, the flexible cable attached to this luminaire
technical help
cannot be replaced; if the cable is damaged, recycle the
luminaire and seek a replacement.
SKU - ALM-SPHR-IV-SAP-TBL-01-EU
SKU - ALM-SPHR-IV-SGE-TBL-01-EU
SKU - ALM-SPHR-IV-BLS-TBL-01-EU
SKU - ALM-SPHR-IV-CHK-TBL-01-EU
IP20
220 - 240V~
SKU - ALM-SPHR-IV-CHR-TBL-01-EU
FOR INDOOR USE ONLY
Advertisement
Summary of Contents for Tala ALM-SPHR-IV-SAP-TBL-01-EU
- Page 1 UK-EU INSTALLATION GUIDE ALUMINA TABLE LAMP Thoughtful lighting, responsibly designed in London. Thank you for making the switch to Tala. Discover the full Tala family at tala.co.uk. BEFORE STARTING Please read instructions thoroughly before installation and keep them for future reference. Please take extreme care when dealing with electrical equipment.
- Page 2 Table Configuration STEP 1 Insert your bulb into the top of the lamp, rotating clockwise until tight. Take care not to tighten too much to avoid breakage. STEP 2 - FOR UK ONLY Insert the EU plug into the UK Adapter, making sure it clicks-in and does not come loose.
-
Page 3: Wall Configuration
Wall Configuration STEP 1 Remove your bulb from the lamp, rotating counter clockwise and set aside. STEP 2 Remove the small lock screw from the side of the lamp with the hex key provided. STEP 3 Slide the lamp towards the cable to disconnect it from the base. - Page 4 Wall Configuration STEP 4 Attach the base to your wall in the orientation shown below. Always choose screws and plugs that are appropriate for the wall. STEP 5 (OPTIONAL) Customers who wish to hard wire the product into the household mains. Please consult a qualified electrician to perform this modification.
- Page 5 Wall Configuration STEP 7 Align the lamp above the base and slide down to lock in place . STEP 8 Insert your bulb into the front of the lamp, rotating clockwise until tight. Take care not to tighten too much to avoid breakage.
-
Page 6: Step 10 - For Uk Only
Join the Community Instagram: @tala | Facebook: talaHQ | Pinterest: TalaLED | Tag: lighttoliveby Tala Studios, 25B Vyner Street, London E2 9DG | +44 20 3026 3246 | hello@tala.co.uk Tala Europe B.V, Bertus Aafjeshove 40, Nieuwegein 3437JN, Netherlands...