SmartAccess LSA-02-02 Installation Manual

System Installation Manual LSA-02-02

Introduction

The Smart Access system lets you control a series of locks via your smartphone or computer

using Bluetooth and Wi-Fi (WiFi coming soon. Please register your device and sign up for email

notifications so we can let you know when that feature is available).

This manual will cover how to set up your system, from electrical connections to installation on

furniture.

Note: It is recommended to set up the system on a work surface before installing in a

cabinet or drawer. Download the app, register at least two fingerprints and test the

system with the app and finger-touch sensor. When you are comfortable with the

operation and you are familiar with it proceed to installation.

The first step to using your new Smart Access device is to connect the external peripherals as

shown below. Each connection has its own specially shaped connector.

The first 4-pin connection (to the right of the finger-touch sensor) can be utilized for an

accessory (Aux/Lock Port) such as a light or an additional lock controlled independently through

the app. The other 4-pin connections are intended for locks. However, all 4-pin connectors can

be used interchangeably for either an accessory or a lock without restriction (Currently all 4-pin

connectors are controlled through the finger-touch sensor).

Table of Contents

Do you have a question about the LSA-02-02 and is the answer not in the manual?

Page 1 System Installation Manual LSA-02-02 Introduction The Smart Access system lets you control a series of locks via your smartphone or computer using Bluetooth and Wi-Fi (WiFi coming soon. Please register your device and sign up for email notifications so we can let you know when that feature is available).
Page 2 Connect Finger-touch sensor and locks to the electronic controller. If you do not intend to utilize all lock ports leave the spare connectors plugged in to the controller to protect the pin ports from damage and dust. Make sure everything is properly connected before plugging in the power adapter to an outlet. The Finger-touch sensor must be connected to the electronic controller prior to connecting the power adapter to an outlet.
Page 3 Installation on Furniture The system can be installed on all types of furniture with doors or drawers that are in close proximity to a power outlet. For metal, please make sure you are installing the appropriate Electronic Controller Model with the external antenna designed for metal furniture and cabinetry or install the Electronic Controller externally.
Page 4 sensor with the nut. For those cases, use a flat bottom hole drill bit of approx. 35mm in order to put the nut on the finger-touch sensor to hold it secure and in place. 5. Identify the location where locks will be installed and measure the distance of the locks to the electronic controller.