Related Manuals for Herzberg HG-8056
Summary of Contents for Herzberg HG-8056
- Page 2 Dear users, Thanks for selecting the HG-8057 advanced garment steamer! Before using the steamer, please carefully read the operating manual, which provides important safety guidelines. 1. Please use standard supply voltage (AC220-240V, 50-60Hz). The connection of incorrect voltage may damage the steamer and cause invalidation of the warranty.
- Page 3 20. Automatic steam exhaust vents are provided on the bottom of the main body for the product, please be careful of steam spraying during use. 21. It is recommended to periodically clean the heater of the steamer so as to remove scale of calcium carbonate and the salt particle type accumulated on the heating body in the steamer, and pull out the plug before cleaning.
- Page 4 I. Product Components II. Product Parameters Model No.:HG-8057 Capacity of water tank: 0.6L Steam pre-heating time: approximate 40 seconds Voltage: 220-240V 50- 60Hz Output power: 2500W...
- Page 5 III. Functional Characteristics 3.1 Display panel of main body 3.2 Functional buttons on handle...
- Page 6 3.3 Knob of nozzle Before using, the nozzle can be adjusted according to the ironing requirements, and the nozzle panel can be rotated leftwards for 90 degrees by press the knob Warning!! 1. If the temperature for the bottom plate of the nozzle does not reduce to the room temperature, do not adjust the nozzle angle so as to avoid burning by high temperature.
- Page 7 IV. Pre-heating and Standby V.Assembly of Product 5.1 Assemble ,and arrange the steam tube and cord...
- Page 8 VI. Operating Guide 6.1 Water filling of water tank Open the water filling plug, fill about 600mL water into the water tank, and put flat on desktop. Warm tips: • In order to elaborate the maximum performance and realize a longer service time, please use purified water. •...
- Page 9 6.2.4 According to the ironing requirements, the steam gear and the temperature gear switch can be set at will so as to set the required gear; 6.3 Ironing of clothes 6.3.1 Steam ironing of clothes (rotate the nozzle into 90 degrees) ℃...
- Page 10 6.3.3 Clothes ironing reference Ironing Temperature Clothing Fabric and Type Clothes Ironing Identification (High temperature) 180-200℃ Cotton, linen and short fiber (Medium temperature) 140-160℃ Silk, wool, nylon, long rayon and copper rayon (Low temperature) 80-120℃ Propylene, propylenes, polyurethane and polypropylene. If no ironing is indicated on the clothing care label, please strictly follow.
- Page 11 VII. Maintenance 7.1 Shutdown and cooling 7.1.1 Long press the power switch of the main body for 3 seconds, the main body gives out a buzzing sound of “beep”, then the steamer is shut down, the power indicator lamp is OFF, pull out the power plug, and wait for at least 30 minutes until the steamer is cooled.
- Page 12 8.3 Remove the water tank, empty water in the water tank, and regulate the extendable rods in place to facilitate storage. IX.Notes to Maintenance 9.1 Remove the steam brush on the steam head, and then use wet cloth to clean. 9.2 Do not use rough or abrasive detergent or solvent.
- Page 13 X. Guidelines to Troubleshooting Problem Possible Solutions ➢ It does not heat. Check whether the plug is correctly plugged. ➢ Check the power supply and switch on it. ➢ It has little steam, or it does not Check whether the water tank is correctly generate steam.
Need help?
Do you have a question about the HG-8056 and is the answer not in the manual?
Questions and answers