HARTING Ha-VIS RFID RF-R400 System Manual page 46

Ha-VIS RFID RF-R400 – System Manual
46
VALID-TIME:
(only for Buffered Read Mode,
Notification Mode and Scan Mode)
(OperatingMode.BufferedReadMode.
Filter.TransponderValidTime)
(OperatingMode.NotificationMode.
Filter.TransponderValidTime)
(OperatingMode.ScanMode.Filter.
TransponderValidTime)
TR-ID:
(only for Buffered Read Mode and
Notification Mode)
Note
Changing of VALID-TIME only becomes effective after writing / saving configuration block
CFG12 to EEPROM.
The address TR-ID-DB-ADR must be in the range of the selected data blocks:
8
DB-ADR ≤ TR-ID-DB-ADR ≤ DB-ADR
8
DB-ADR, DB-N of CFG11.
IN-EV-FLT:
(OperatingMode.BufferedReadMode.
Filter.Enable_InputXEvent) x=1,2
(OperatingMode.NotificationMode.
Filter.Enable_InputXEvent) x=1,2
(0...65535 x 100 ms = 0 ms ... 6553,5 sec)
The period of time during which a transponder will not be
nd
reported a 2 time.
TR-ID sets the parameters for transponder identification.
If several transponders have the same content in the
addressed data block, only one da-taset will be generated.
Byte 2 3
Function TR-ID-
SOURCE
TR-ID-SOURCE:
(OperatingMode.Miscellaneous.
TransponderIdentification.Source)
Sets the data source for transponder identification.
b0 data block
b1 Serial Number
TR-ID-DB-ADR:
(OperatingMode.Miscellaneous.
TransponderIdentification.DataBlockNo)
Sets the address of the data block for transponder
identification. If ID-SOURCE selects the serial number as data
source, the ID-DB-ADR will be ignored.
TR-ID-DB-N:
(OperatingMode.Miscellaneous.
TransponderIdentification.Source)
Sets the number of data blocks to be read for transponder
identification. If ID-SOURCE selects the serial number as data
source, the ID-DBN will be ignored
1 1
+ DB-N – 1.
Input Event Filter
Bit 7 6 5
Function – – -
Input1,2:
b0 input event will not be notified
b1 input event will be notified
HARTING IT Software Development GmbH & Co. KG
4 5
TR-ID-DB-ADR TR-ID-DB-N
4 3 2 1 0
– – – Input2 Input1