Table of Contents
Advertisement
INSTALLATION AND OPERATION INSTRUCTIONS
MODEL GRL-850-AU IS AUSTRALIAN
GAS ASSOCIATION APPROVED FOR
NATURAL GAS OR PROPANE AS A
DECORATIVE GAS LOG.
Refer to the appliance data plates for gas
consumptions and pressures.
Installation of this appliance should only be
carried out by an authorized person in accor-
dance with the manufacturer's instructions. All
relevant codes and regulations laid down by
the gas piping authorities, municipal building
regulations, electrical wiring regulations and
the requirements of the AGA Gas Installation
Code must be observed.
This appliance and its components are tested
and safe when installed in accordance with this
Installation Manual. Report to your dealer any
parts damaged in shipment. Read all instruc-
tions before starting installation and follow
these instructions carefully during installation
to ensure maximum benefi t and safety. Failure
to follow them will void your warranty and may
present a fi re hazard.
Copyright 2007
Heat & Glo, a brand of Hearth & Home Technologies Inc.
7571 215th Street West, Lakeville, MN 55044, U.S.A.
Printed in U.S.A.
2
PLEASE READ THIS MANUAL BEFORE INSTALLING
AND USING THIS APPLIANCE.
IMPORTANT: Read all instructions carefully before starting installation.
Failure to follow these installation instructions may result in a possible fi re
hazard and will void the warranty. Save this Manual for future reference.
Heat & Glo • GRL-850-AU, GRL-850LP-AU • 2011-900 Rev. i • 8/10
The Heat & Glo, a brand of Hearth & Home
Technologies Inc. warranty will be voided by,
and Heat & Glo, a brand of Hearth & Home
Technologies Inc. disclaims any responsibility
for the following actions:
• Installation of any damaged heater.
• Modifi cation of the heater installation other
than as instructed by Heat & Glo, a brand
of Hearth & Home Technologies Inc.
• Improper positioning of the gas logs.
• Installation and/or use of any component
part not manufactured or approved by
Heat & Glo, a brand of Hearth & Home
Technologies Inc., not withstanding any
independent testing laboratory or other
party approval of such component part
or accessory.
Advertisement
Table of Contents
