Advertisement
ASSEMBLY
ASSEMBLY
Tube with Tapered Ends
Tube with Tapered
End and Regular End
1
• Place a tube with tapered end and regular end on a flat surface.
• Fit a tube with tapered ends into the regular end, as shown.
Hint: The tube assembly should form this shape
• Align the holes in the tubes.
• Fit a lock nut, rounded side out, into the hex hole on the inside of the
tube with tapered end and regular end.
• Insert a screw through the outside of the tube with tapered end and
regular end.
• While holding the lock nut in place, tighten the screw.
Long End
Side Tube
2
2
• Fit the long end of a side tube onto either tapered end of the assembly.
• Align the holes in the two tubes.
Hint: If the holes in the tubes do not align, remove the side tube and place
it on the other end of the assembly.
• Fit a lock nut, rounded side out, into the hex hole in the inside of
the side tube.
• Insert a screw through the hole on the outside of the side tube.
• While holding the lock nut in place, tighten the screw.
Rounded
Side
.
Rounded
Tapered
End
Side Tube
3
• Fit the long end of the other side tube onto the other tapered end of
the assembly.
• Align the holes in the two tubes.
• Fit a lock nut, rounded side out, into the hex hole on the inside of
the side tube.
• Insert a screw through the hole on the outside of the side tube.
• While holding the lock nut in place, tighten the screw.
Side
4
• Lay the net on a flat surface.
• Note the long sleeve, two medium sleeves and two short sleeves on the net.
- Long sleeve is the top of the net.
3
Tapered
End
Long End
TOP OF NET
BOTTOM OF NET
Rounded
Side
Long Sleeve
Advertisement
