Panasonic CT-30WX54J Service Manual page 89

The DG-Board is assembled on the main chassis (A-Board) plugged at the A13 and A14 (DG3 and
DG4 respectively) connectors.
NOTE
This board is not-serviceable.
When removing this board pull carefully.
DF-Board
Plugs onto the right side of the D-Board at D14 and D16 connectors (P2, P11, P12 and P3 on P-Board,
respectively); First remove the screw that holds the metal board, from the flyback and from the
chassis tray and then use a flat head screwdriverto release the connector locking tabs and pull upwards
the board.
G-Board
Mated to A-Board by three flexible connectors A1, A2, A3 and D9 from D-Board. To remove this
board, first unplug the flexible connectors, then RT1 and G5 connectors, then pull upwards the board
while unlock the tabs from the chassis tray.
Buttons assembly
This assembly is hold with two screws to the front cabinet. To remove, pull out the chassis and
remove the two screws from each side of the assembly.
Speakers
Each speaker is secured to a plastic base with 4 screws, and the plastic base is secured to the from
cabinet with three screws. To remove the small speaker from the plastic base, unscrew the four
screws; To remove the bigger speaker, disassemblythe plastic base by removing the five screws from
the back of the plastic base.
NOTE
When reassembling speakers be sure to connect the speaker wires to the correct speaker lead (+) (-)
10.1 Disassembly for CRT replacement
TOP PREVIOUS NEXT