Panasonic CT-30WX54J Service Manual page 120
Hide thumbs
Also See for CT-30WX54J:
- Operating instructions manual (96 pages) ,
- Service manual (32 pages)
Table of Contents
Advertisement
15.3 (NTSC) Sub-Contrast
Service DAC adjustment (CUT-G, CONT)
TOP PREVIOUS NEXT
This adjustment is factory set. Do not adjust unless repairs are made to associated circuit, the CRT Board
or when the CRT is replaced.
Preparation
1. Apply a colorbar pattern.
2. Set the PICTURE settings to normal.
3. Set color to minimum (no color on picture).
4. Set PICTURE mode to VIVID
5. Connect the oscilloscope to TP47G.
Procedure
1. In the service mode, select DAC for brightness adjustment BRIGH and set data to 1 D0.
2. In service mode, select DAC for green cutoff adjustment CUT-G, and adjust data to obtain 2.2 V
between 7.5IRE and GND level at TP47G. (See waveform detail)
3. In service mode, select DAC for contrast adjustment CONT, and adjust data to obtain 2.3±0.1V
between 7.5IRE and 100IRE level at TP47G. (See waveform detail)
Advertisement
Table of Contents
