Settings
Your Detector
Intro
Operation
Customer
Warranty
Assistance
Setting Dim Default
You can set the default level for Dim mode (Dim, Dimmer or Dark)
either in Program mode or directly using the Select/Dim button.
Secondary Icons
Select/Dim Button
Press and hold
Notice
To Set the Display Dim Mode Default Directly Using the Set/Dim Button
Press and hold the
Tone or Voice
Visual Display
Select/Dim button
One beep each time the
Cycles — see chart above
display cycles
Release the Select/Dim
None
Dim, Dimmer or Dark
button to select the
current display as
default.
To Set the Display Dim Mode Default Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode,
Tone
Visual Display
go to Display Dim,
Two beeps
Dim
Dimmer or Dark.
One beep
Dimmer
One beep
Dark
24 English
Your Detector
Intro
Operation
Detection
Signals Detected
The tables on the following pages show you the types of Signals your
detector will detect, as well as the visual alerts it provides for each of them.
Secondary Icons
Audio Alerts
Dim
A distinctly different Alert tone is used for each type of signal detected
Press
(including separate tones for each laser signal). For X, K, Ka and Ku band
and hold
Dark
radar signals, the tones will repeat faster as you approach the signal
Notice
Select/Dim
source. The repeat rate of the tones gives you useful information about
button
Dimmer
the signal detected. See responding to alerts on page 28.
Visual Display
An indication of the type of signal detected will appear in the DigiView Data
Display. During X, K, Ka and Ku alerts, you will also see from one to five
vertical bars, indicating the strength of the signal detected.
Signal Strength Chart
Signal Strength = 1
(Weakest Signal)
-
Signal Strength = 4
-
- -
- -
- - -
- - - -
Voice
Dim
Dimmer
Dark
Detection
Customer
Warranty
Assistance
Signal Strength = 2
Signal Strength = 3
1
2
- -
3
-
- -
- -
- - -
Signal Strength = 5
(Strongest Signal)
- _
-
- -
4
- - - - _
- - -
5
- - -
- - - -
Nothing Comes Close to a Cobra
•
®
25