Hardware Installation - Linksys WCF12 User Manual

Hardware Installation

1. Insert the Wireless CompactFlash Card into your PDA.
2. The screen in Figure 3-15 will appear. The default setting is Use server-
assigned IP address. In most cases, you should keep the default setting.
However, if you are using fixed IP addresses on your wireless network, then
click the radio button next to Use specific IP address, and complete the IP
address, Subnet mask, and Default gateway fields.
3. Click the OK button to close this screen.
The installation of the Wireless CompactFlash Card is complete.
Proceed to "Chapter 4: The Wireless CompactFlash Card's
Configuration Utility" if you wish to further customize
its configuration.
12
Instant Wireless
Figure 3-14
Series Wireless CompactFlash Card
TM
Figure 3-15
13