Guarantee And Support; Guarantee Restrictions - Philips Sonicare 2 Series Manual

1 To deplete the rechargeable battery of any charge, remove the handle
from the charger, turn on the Sonicare and let it operate until it stops.
Repeat this step until you can no longer turn on the Sonicare.
2 Insert a small standard screwdriver into the bottom of the handle
and turn it counter-clockwise to remove the screw. Pull the end
cap off of the handle (Fig. 10).
3 Insert the screwdriver between the handle and the internal frame.
Tilt the screwdriver to loosen the handle (Fig. 11).
4 Remove the internal frame from the handle. (Fig. 12)
5 Remove the rubbers that are on top and below the battery (Fig. 13).
6 Insert the screwdriver between the battery and the frame. Tilt the
screwdriver to pop the battery out of the frame (Fig. 14).
7 Place some tape over the ends of the battery to avoid any short-
circuiting due to residual energy in the battery (Fig. 15).

Guarantee and support

If you need information or support, please visit www.philips.com/
support or read the separate worldwide guarantee leaflet.

Guarantee restrictions

The terms of the international guarantee do not cover the following:
- Brush heads.
- Damage caused by use of unauthorised replacement parts.
- Damage caused by misuse, abuse, neglect, alterations or unauthorised
repair.
- Normal wear and tear, including chips, scratches, abrasions,
discolouration or fading.
ENGLISH
13