Advertisement
2. introDuction
unique and innovative 360° swivel and tilt function enables the light source to be positioned in any direction. exclusive patented design
owned and registered to sealey. state of the art coB led providing up to 250 lumens output with a cri - 80 rating. 120° spread of light,
illuminating the whole work area. includes an additional high power 3W led in the end for use as a directional torch. features two swivel
hooks and three rubber covered magnets, two on the rear and one on the end, which allow hands free operation. High quality 2.2Ah lithium-
ion battery for longer life, no memory effect and a much slower discharge than traditional ni-mH batteries. micro usB charging port. supplied
with mains and in-car charger.
3. specification
model no: ............................................................... leD3603
Battery: .....................................................3.7V - 2.2Ah li-ion
led quantity: .........................................1 coB led + 1 led
cri rating side: .................................................................. 80
lumen output side/top: .......................................... 250/100lm
operating time side/top: ..............................................3.5/8hr
charging time: ................................................................5.5hr
minimum length: ......................................................... 260mm
maximum length: ........................................................ 280mm
important WArrAntY informAtion
V
The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time.
We will provide warranty against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.
If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances
we will not replace the battery regardless of whether it is less than one year old.
4. operation
Refer to fig.1
4.1.
connect the usB lead to the charger unit and the socket on the rear of the lamp. Plug into power supply and turn on, the charging
led on the lamp will light red to show that charging has commenced.
4.2.
When the battery has fully charged the led will turn Green.
4.3.
direct the lens away from your eyes before switching on.
4.4.
toggle the lamp between the end light and side light using the on/off switch.
4.5.
the lamp may be suspended by the hooks or attached to any ferrous surface by using the magnets.
4.6.
When the light is hanging from the hook it can be rotated through 360° for more precise positioning.
4.7.
separate the top and bottom sections by pulling apart. When attached to a ferrous surface, using the base magnet, the lamp can
be rotated to shine in any direction.
fig.1
© Jack sealey limited
All manuals and user guides at all-guides.com
Original Language Version
led3603 series | issue 1 - 02/09/15
Advertisement
