Advertisement
MOTION + DAY/NIGHT SENSOR
The sensor can be configured to work for the environment installed. Features such as Sensitivity, Time on, and
LUX can be configured. De-energize fixture prior to making adjustments in order for them to take effect!
DIP SWITCHES
IMPORTANT:
persons or objects moving towards the sensor are detected best.
NOTE: The high frequency of the output of this sensor is <10Mw – that is just one 100
power of a mobile phone or the output of a microwave oven.
These instructions may not cover all details or variations of this product for your equipment or installation requirements. Should further
information not covered by these instructions be required, please contact Larson Electronics at 1-800-369-6671 for further assistance.
Please visit LarsonElectronics.com for Warranty and Return information.
Larson Electronics, LLC
Detection Area
Detection area can be reduced by selecting the combination on the DIP
switches to fit precisely each application.
Hold Time
Refers to the time period the lamp remains illuminated after no motion is
detected.
Daylight Sensor
The sensor can be set to only allow the lamp to illuminate below a defined
ambient brightness threshold. When set to Disable mode, the daylight sensor
will switch on the lamp when motion is detected regardless of ambient light
level. 30lux, 50lux, 100lux,: twilight operation, 5lux, 15lux: darkness operation
only.
Phone: (800) 369-6671
Fax: (903) 498-3364
HALP-48-3L-LED-DNMS
th
of the transmission
www.larsonelectronics.com
2 of 2
Advertisement
