Table of Contents
Advertisement
Side View
FIGURE 11: Attachment of Model 4810 to Concrete Form
INSTALLATION ON EXISTING STRUCTURES
The lugs welded to the edge of the cell can be used to hold the cell against the
structure using nails, lag bolts, tie wire, etc. Even if the surface is smooth, but
especially when the surface is rough or irregular, a mortar pad between the cell
and the structure is required. See Figure 12 below.
Side View
FIGURE 12: Model 4810 Contact Pressure Cell Installation
MODEL 4800 SERIES VW EARTH PRESSURE CELLS | INSTALLATION | 9
Concrete Form
Excess Cable
(coiled inside blockout)
Pressure Cell
Double Headed Nails
(through mounting lugs, 4 places)
Front View
Pipe Straps & Conduit
Concrete Nails
(4 places)
Zone with large aggregate removed
Mortar Pad
Front View
11:
12:
Advertisement
Table of Contents
