Table of Contents
Advertisement
ANTI-TIP BLOCK
Figure 3
NORMAL INSTALLATION STEPS
ANTI-TIP BLOCK INSTALLATION INSTRUCTIONS
To reduce the risk of tipping of the drawer, the Anti-Tip block must be properly
13/16- installed located 14 inches above the floor on which the Microwave
Drawer will sit. The 6-inch Anti-Tip block must be provided by the installer.
See Figures 1 and 3. The Anti-Tip block prevents serious injury that might result
from spilled hot liquids. If the Microwave Drawer is ever moved to a different
location, the Anti-Tip block must also be moved and installed , When installed to the
wall make sure that
secured in wood or metal so that the block is totally stable. When fastening,
be sure that the screws do not penetrate electrical wiring or plumbing. The electrical
requirements are a 120 volt 60 Hz, AC only,l5 amp. or more protected electrical supply.
recommended that a separate circuit serving only this appliance be provided.
It is
The drawer is equipped with a 3-prong grounding plug, It must be plugged into a wall
receptacle that is
have a qualified electrician install a correct wall receptacle.
Note: If you have any questions about the grounding or electrical Instructions, consult
a qualified electrician or service person.
*Can also be installed using an electrical outlet in an adjacent cabinet within the area
where the provided electrical cord can reach.Always check electrical codes ,for requirements.
Anti Tip
block
the
screws completely penetrate the dry wall and are
properly installed and grounded. Should you only have 2-prong outlet,
ELECTRICAL OUTLET
Su gge sted el ectric al
outlet loc ation
11
4''
Figure 4
Advertisement
Table of Contents
