Linksys BEFN2PE User Manual page 9

4. The Cable/DSL Voice Enabler 's Setup page will appear.
N N o o t t e e : : The Setup
page shown in
this graphic may
differ from the
one seen on your
Voice Enabler.
5. Configure the following values.
Host Name This field allows you to supply a host name for the Voice
enabler. In most cases, leaving this field blank will work.
LAN IP Address These values refer to your internal network settings. You
can change the IP Address information of the Voice Enabler here. Select
either Obtain an IP Address Automatically (if you use DHCP), or select
Specify an IP Address (if you are using a static IP address). If you select
Specify an IP Address, you may have to enter the values for your Subnet
Mask, your Default Gateway Address and your DNS. Verify that the set-
tings match the TCP/IP settings of the other computers on your network.
If you are unsure about automatic IP address assignment or static IP
addreses, see the beginning of this section. All values that you enter here
must be compatible with the rest of your network. You can also set the IP
Address for the Voice Enabler using an attached telephone. For more
information, see the beginning of this section.
11
Instant Broadband TM Series EtherFast ® Cable/DSL Voice Enabler powered by Net2Phone
Net2Phone Enter the Account Number and the Personal Identification
Number (PIN) that appear on the Net2Phone/Linksys Rechargeable Calling
Card that came in your Voice Enabler's box.
6. When you have properly configured the Setup page, click Apply. The
following page will appear, notifying you that all of your settings have
been accepted. From this page you can either continue with your Voice
Enabler's setup, or you can link to the Net2Phone/Linksys webpage in
order to activate your Net2Phone account (if your Internet connection is
already configured properly).
7. Activating Your Net2Phone Account.
a. If you have not activated your Net2Phone account through the
Linksys/Net2Phone website, please select the link that will direct
you to this website. (Follow the instructions to activate your
account.) Remember to return here after you have completed
activation and continue from this step.
b. If you have already activated your account (or do not wish to acti-
vate it at this time), click on Continue.
N N o o t t e e : : If you choose not to activate your Net2Phone account now, you can do it at any
time by going to the H H e e l l p p tab in the Voice Enabler's Web-based Utility. You will not be
able to make any telephone calls using the Voice Enabler unti l you activate your
Net2Phone account.
8. Close the browser window.
Your Cable/DSL Voice Enabler is now configured to your
network and you are ready to make phone calls.
SM
12