Page 1
Sheet What is the WK-MOD? The WK-MOD-xxx-x is a keypad for use with Rako wired systems. It is available in a wide variety of button configurations including: WK-MOD-040-B - 4 button - Scene 1, off, fade up & fade down - Black buttons WK-MOD-070-B - 7 button - Scenes 1-4, off, up &...
Page 2
Before installing the WK-MOD: The WK-MOD comes in two sections “Front” and “Back” ; they are referred to as such in the following installation guide. The “Back” section is just a connection board for the CAT5/6 cable. The “Front” section contains all memory and programming -----------------WARNING--------------- The WK-MOD has four visible screws on the “Front”...
Page 3
Terminate the WK-MOD as required. Step 3 “Terminating the WK-MOD” section of this manual. Screw the grid containing the back section into the back-box. The back section of the WK-MOD is now installed and is ready for the front section. Clip the front section of the WK-MOD into the Step 4 grid.
Page 4
Terminating the WK-MOD It is important to terminate WK-MOD correctly otherwise the wired system will not function. The termination that is required depends on the nature of the installation and the position of the RAK-LINK within the system. No Term - Both Jumpers removed Used when the WK-MOD is not at the end of line.