Important; Product Safety - FX LAB G007PA Installation

These instructions should be read carefully and left with the user of the product for
future reference.
You must inspect this product and its power lead before use for any signs of
damage. If the products or its lead are damaged in anyway, DO NOT use it, and
contact your supplier immediately.
•
Professional install product only. This product must only be installed by a
qualified professional person and only after conducting a site survey and risk
assessment for its suitability to be used in that location. The installation must
conform to all local wiring and safety legislation.
•
This product must be wired through a switched fused spur.
•
For indoor use only.
•
Do not use in bathrooms, or in wet or damp locations.
•
Only attached to strong stable surfaces that can withstand the weight of the
product.
•
Do not leave this product switched on when not attended.
•
The product should be switched off and disconnected from the mains when not
in use.
•
The product and its electrical parts should be inspected for damage, wear and
the ingress of dust and dirt by a professional person regularly. If any are found
stop using immediate and repair or replace.
•
Only use this product for its intended use.
•
Children must not play with this product
•
Do not attach or allow items to be deposited in this product.
•
Do not swing from or attempt to hold the unit.
•
This product should be mounted at a heigh of at least 2m to the apex of the
unit.
•
Do not use in the vicinity of petrol or other flammable gasses.
•
Do not use in the vicinity of heat sources such as fires or cookers.
•
Always wear gloves when handling this product. Cut risk

IMPORTANT

Installer and Users please note:
BEFORE USE

PRODUCT SAFETY

Page 2