FX LAB G002GKB Manual

These instructions should be read carefully and left with the user of the product for future reference.
You must inspect the product for damage. If the product is damaged, DO NOT use it, and contact your supplier immediately.

Children should be supervised to ensure that they do not play with the unit.

Do not place on carpet or other soft surfaces.

Do not point the bubble output towards sensitive electronic equipment.

Do not put anything apart from bubble fluid in the tank (except when cleaning as described on page 4).

Do not move the unit whilst it is operating.

For indoor use only.
Note:
After prolonged use, the floor immediately in front of the unit may become slippery.
To operate:
Place the G002GKB on a firm flat surface. Ensure that the bubble outlet (at the front) is not obstructed. Alternatively, the
appliance may be suspended from the attached hanging bracket.
Insert 8 x AA batteries or connect to the mains using a 12V Regulated power supply rated at a minimum of 700mA (Equivalent
to a P003C).
Move the power switch on the rear panel to the ON (I) position. To operate either switch the Auto Battery switch to ON (I) if you
wish the unit to work permanently or in the Off (0) position you can turn the unit Off and ON using the supplied remote control.
To fill the tank:
Disconnect from the mains supply.
Fill the tank (at the front) with Venü Benchmark Bubble Fluid (catalogue numbers: FL801 for a 1 litre bottle or FL805 for a 5 litre
bottle)
To empty the tank:
Use a funnel (not provided) and tip the bubble machine forwards and sideways so that the unused bubble fluid flows out of the
front corner of the tank. Return the unused fluid to the bottle.
G002GKB
Bubble Machine
IMPORTANT
Installer and Users please note:

BEFORE USE

PRODUCT SAFETY

OPERATION

Page 1